Wednesday

Samsung CLP-300 Error cause dirty with dust

Try
1- turn off and remove power cable;
2- remove paper drawer;
3- remove image unit - don not let it under sun light. cover it.
4- put the printer upside down;
5- look at the axle of the big central rubber roller:

5.1- you will see both sides have a plastic balancer and locker.
5.2- left one has a small "finger" that locks it from slide.
5.3-
take your cellphone and do a photo of the present position of the axle
and the pieces as you will need to remember it after.

6-light and carefully, lift this small finger from the axle and slide the locker half inch to the center;
7-
after this, you have the axlee in a so so free way. You can move
(rotate) it, if you lift and free the inside gear at left end;
8- at
the central drumm, there is two locks, one each side. If you release
them, you can remove a type of a plastic shell with the rubber belt
attached to.
8.1- to unlock the shell you need to rotate the axle and
position the locks in a convenient way. So, rotate it again, and so,
remove the shell.
9-I removed the rubber belt, washed it with water only.
when
repositioning the belt on the shell, observe it and put in a different
position, as the slick area fits inside the shell, so a new surface is
out.
10- mount it a reverse order.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.